Block paving Cost Calculator
Block paving has been the UK’s second-favourite driveway material for 30 years, and in 2026 it still runs about £80–£140/m² fitted — the spread comes down to the block you pick and the laying pattern more than anything else. This calculator uses the same published figures as our block paving cost guide, adjusted for your region, so you get a realistic per-square-metre range in about 30 seconds. Set your block type and any extras below, then use it to sense-check the quotes you get back.
Open the calculator →Price block paving in 30 seconds
3 steps, using the figures from our cost guide.
How this calculator works
Every figure in this calculator is the one published in the cost table on our block paving guide. Pick the option that matches your job and the calculator returns that published range, adjusted for your region - it does not model anything the guide does not already say.
That is deliberate. A calculator whose rates drift from the page it sits under is worse than no calculator, because two numbers on the same site disagree.
What it cannot know: access, the condition of what is already there, and anything structural. Those are what separate three real quotes from each other.
Published block paving costs (2026)
| Option | Typical 2026 cost | Notes |
|---|---|---|
| Concrete blocks (Marshalls Drivese | £80–£100 | |
| Clay pavers (Wienerberger, Marshal | £110–£140 | |
| Permeable blocks (Marshalls Tegula | £100–£130 | |
| Mixed-size/textured premium (Tegul | £95–£130 |
These are the figures from our block paving cost guide.
What pushes a block paving job up or down
The per-square-metre rate is only half the story. On most driveways the sub-base does more to the final bill than the blocks on top: a drive that carries cars needs a deeper, well-compacted sub-base than a patio, and if the ground is soft or was never dug out properly, that is where the money goes. Edging and kerbs, cutting blocks around curves and manhole covers, and lifting an old concrete or tarmac surface first all add labour that a headline £/m² figure never shows.
Two things are worth budgeting for on a front garden: drainage and access. Since 2008 a new front driveway over five square metres has had to drain on-site rather than run water into the road, so permeable blocks or a soakaway usually become part of the job — the Planning Portal sets out when you need permission. And a narrow side entrance, or nowhere to tip a grab lorry, slows both the dig and the muck-away — exactly the kind of thing a calculator cannot see and a site visit can. For the full breakdown see our block paving cost guide, or compare it against a tarmac driveway if you are weighing up surfaces.
Block paving calculator — FAQs
It uses the same published figures as the cost guide it sits under, adjusted for your region. It is a budgeting estimate, not a quote - only a site visit produces one of those.
Related cost guides
- Block paving cost guide — The full price guide
- All driveways services — Browse the hub
- All BestBuilders services — Every trade we cover
Get 3 Free Quotes
60 seconds · No spam · No obligation